• Telefone  - Betta Hidroturbinas
  • + 55 (16) 2104 5522
  • WhatsApp - Betta Hidroturbinas
  • +55 (16) 99977-0660
  • EN

PUMPING

read below the more frequent doubts about this theme.
did not find the answer? please contact us.

WHAT IS THE FUNCTION OF THE ANTI-SHOT VALVE PRESENT AT TURBOBOMBA?

The anti-shot valve has the purpose of closing the water supply of the assembly, interrupting the operation in case of breakage of the retaining tube, which would cause rotation excess due to a reduction in the pressure at the pump outlet.

Was this information helpful to you? Positivo Negativo

CAN BE PUMPING WATER AND GENERATING ELECTRICITY WITH THE SAME EQUIPMENT?

Turbobomba Betta and the Betta Hydropower Plants are different equipment.

Besides the rotation difference and the necessary accessories in the equipment for power generation, as electronic regulator and others, the cost of such adaptation would equal to the acquisition of the two systems to work in parallel.

Was this information helpful to you? Positivo Negativo

CAN THE TURBO RODA / TURBO BETTA CAN BE USED IN MY IRRIGATION PROJECT?

The Turbo Roda Betta and Turbobomba Betta are widely used in irrigation projects. However, because no other fuel is used other than water, the flow pumped to the irrigation project will depend on the water drop and flow rate to drive the equipment.

Considering that the equipment works 24 hours without electricity or diesel consumption, the project can be adapted according to the acquired pumped flow.

Was this information helpful to you? Positivo Negativo

WHAT IS THE FLOW PUMPED BY THE TURBO RODA / TURBO PUMP ASSEMBLIES?

The flow pumped by the Turbobomba Betta set depends on the characteristics of the location chosen for installation (see dimensioning), which also determines which model should be used.

As for the Turbo Roda Betta equipment, the characteristics of the performance will define the pumped flow, which the nozzle for flow control of the drive should be used and the combination of pulleys required.

Was this information helpful to you? Positivo Negativo

IF THERE IS FALL IN THE FLOW, THE EQUIPMENT WILL STOP?

Michell Banki hydraulic turbines, used in the Turbobomba Betta, have a lever-operated flow regulator profile, which allows to reduce the drive flow rate up to 35% while maintaining its operation.

In the Turbo Roda Betta the versatility is even greater, being only necessary to use the complementary reducer of flow suitable for the situation.

Was this information helpful to you? Positivo Negativo

THE EQUIPMENT CAN STAY AT WEATHER?

The Turbo Bomba Betta should receive a simple cover, supported by four pillars. The Turbo Roda Betta is ready to work outdoors.

Was this information helpful to you? Positivo Negativo

THE MAINTENANCE OF TURBO RODA / TURBOBOMBA BETTA NEEDS A SPECIALIZED TECHNICIAN?

Periodic maintenance of the equipment does not require specialized labor, which is done by removing a minimum number of parts and this procedure is explained step by step in our assembly and maintenance manual.

Was this information helpful to you? Positivo Negativo

THE WATER TO BE PUMPED HAS TO BE THE SAME THAT OPERATES THE TURBINE?

No. It is common to use water from a dam or stream to drive the turbine and supply the pump, the water to be pumped can be made through a mine or other clean source that is used in the the turbine.

Was this information helpful to you? Positivo Negativo

HOW MUCH TURBO RODA / TURBO BOMBA BETTA CAN PUMP AND THE HOW DEEP CAN SUCTION?

Depending on the geometric gradient, Turbobomba Betta has the capacity to pump over distances of up to 30 km. It is important that the booster network be designed by a professional of the branch, following the existing norms. As for the depth of suction, it can reach 4 meters in a maximum distance of 50 meters.

Turbo Roda Betta has pumping capacity according to each model, and can reach up to 10km away. As for the depth of suction, this can reach 3 meters in a maximum distance of 10 meters, according to each model.

Was this information helpful to you? Positivo Negativo

WHAT IS THE MINIMUM AND THE LOW FLOW NECESSARY FOR THE TURBO BOMBA BETA START TO WORK?

The minimum water drop for the activation of water pumping equipment is 1.5 meters (level difference measured vertically). However, the adduction tube may follow the slope of the ground until the equipment is installed as low as possible. The larger the existing waterfall, the greater the flow pumped by the same equipment, whether this Turbo Roda Betta or Turbobomba Betta.

As for the flow rate, the minimum amount of water required is 0.9 liters / second for Turbo Roda Betta. However, this may vary depending on the existing water fall, as well as the pump set-up data (pumping height and distance).

Was this information helpful to you? Positivo Negativo

In what way we can do water collection for the pump?

The pump can be supplied by gravity. In this case, water decanters shall be used to remove sand or other suspended solids in the water, at a maximum level of 1 meter above the Pump. There will be no need to eliminate air in the adduction tube, or use a valve to keep the tube filled.

Another alternative will be suction capture, respecting the depth limits mentioned above. In this case, it is also important that the tubulation is sized by a professional, so that the friction loss does not exceed the suction limit.

Was this information helpful to you? Positivo Negativo

HOW MUCH COST A TURBOBOMBA BETTA EQUIPMENT ?

Like the pumped flow, the cost of the Turbobomba Betta equipment is directly related to the characteristics of the chosen location (see Dimensioning), and there may be several models for the same flow, but with different characteristics and values.

Was this information helpful to you? Positivo Negativo

Utilizamos cookies para melhorar sua experiência. Saiba mais em nossa Política de Privacidade.

Falar com a Betta Hidroturbinas